This HDMI extender includes both a transmitter and a receiver unit. It can extend HDMI signal up to 120 meters over single network cables, and the supported resolution up to 1080p@60Hz. This extender is HDCP compliant.
Important Safety instructions:
1 Do not mix up the HDMI EXTENDER sender and HDMI EXTENDER receiver,
2 Do not plug-in/out the cables when it is in use
3. Use DC 5V power supply only. Make sure the specification matched if using 3rd party DC adapters.
● INTRODUCTION
This HDMI extender includes both a transmitter and a receiver unit. It can extend HDMI signal up to 120 meters over single network cables, and the supported resolution up to 1080p@60Hz. This extender is HDCP compliant.
● Installation Requirements
1. HDMI source device (computer graphics card, DVD,PS3, HD monitoring equipment etc).
2. HDMI display device like SDTV, HDTV, projector with HDMI port.
3. Network cables; UTP/STP Cat5e/6 network cables, which fllowing the standard of IEEE- 5688.
● FAQ
Q: TV display "Walting for connection"?
A: Please check if the power supply of TX (Sender) and switcher (if used) is connected, and make sure connecting cable is frmly.
Q: TV display. "Please check the TX input slgnal"?
A: 1) please check if there is a HDMI signal input of TX.
2) Try to connect the signal source directly to display device to see if there is singal output from source device or change the signal source, HDMI cable and try again.
Q: Display not fluent, not stable?
A: 1) Please check the cable length between the TX to switch, the switch to the RX and the connection between each level is within the required range.
2) Click the'reset" button on the TX/RX front panel, reset and reconnect.
Media Contact
Company Name: Lenkeng
Email:Send Email
Phone: 86-755-83593885
Country: China
Website: https://www.lenkeng.com/
